Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car



Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
- 11. Electric equipment
   11.1. Specifications
   11.2. Battery
   + 11.3. System of ignition
   11.4. Coil (i) of ignition
   11.5. Ignition distributor
   11.6. Check and installation of the moment of ignition
   11.7. Block of electronic ignition
   11.8. Induction sensor
   + 11.9. System of a charge of the battery
   + 11:10. Generator
   11:11. System of launch of the engine
   + 11:12. Starter electric motor
   11:13. Traction relay
   11:14. Check of tension
   11:15. Detection of short circuit
   11:16. Check of reliability of grounding
   11:17. Check of integrity of a chain
   11:18. Finding of not closed chain
   11:19. Search of malfunctions
   11:20. Safety locks
   11:21. Fusible crossing points
   11:22. Breakers
   11:23. Relay
   11:24. Breaker of indexes of turn / alarm system
   11:25. Switch of indexes of turn
   11:26. Lock of ignition and drum of the lock
   11:27. Switch of external lighting
   11:28. Screen wiper switch
   11:29. Lamps of headlights
   11:30. Adjustment of headlights
   11:31. Headlight case
   11:32. Replacement of lamps
   11:33. Receiver and loudspeakers
   11:34. Antenna
   + 11:35. Screen wiper electric motor
   11:36. Switch of heating of back glass
   11:37. Heater of back glass
   11:38. Guard of devices
   11:39. Sound signal
   11:40. Electric drive of mirrors
   11:41. Cruise control
   + 11:42. Window regulator electric drive
   11:43. Electric drive of door locks
   11:44. Safety cushions
+ 12. Electrical circuitries


2403db43

11.6. Check and installation of the moment of ignition

GENERAL INFORMATION

Prevention

The procedure of installation of the moment of ignition is applicable to almost all cars which are considered in this manual. If the order of installation of ignition specified in the podkapotny plate of the car differs from described below, then be guided by the instruction of the plate.


PERFORMANCE ORDER
1. Connect a tachometer, being guided by the instruction of the manufacturer of the device 1 – a tachometer, 2 – the battery).
2. Find the diagnostic socket and close накоротко conclusions of E1 and TE1 (the place of installation of the socket is specified in subsection 5.10).
3. At the switched-off ignition connect a stroboscope, being guided by the instruction of the manufacturer of the device. Almost all stroboscopes eat from the battery. Besides, on a high-voltage wire of the 1st cylinder the winding of the induction sensor of a stroboscope puts on.
4. Find ignition moment tags on a forward cover and on a crankshaft pulley.
5. Warm up the engine, be convinced that turns of idling of the engine meet standard.
6. Direct stroboscope light to a scale. The tag on a pulley of the crankshaft has to be opposite to the corresponding division of a scale.
7. If necessary weaken a bolt of fastening of the distributor and slowly turning the distributor, determine the ignition moment (see subsection 11.1).
8. Tighten a bolt of the distributor and again check installation of the moment of ignition.
9. Remove a crossing point and be convinced that the corner of an advancing of ignition meets standard.
10. Switch off ignition and remove devices.