Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car



Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
- 11. Electric equipment
   11.1. Specifications
   11.2. Battery
   + 11.3. System of ignition
   11.4. Coil (i) of ignition
   11.5. Ignition distributor
   11.6. Check and installation of the moment of ignition
   11.7. Block of electronic ignition
   11.8. Induction sensor
   + 11.9. System of a charge of the battery
   - 11:10. Generator
      11.10.1. Generator details
   11:11. System of launch of the engine
   + 11:12. Starter electric motor
   11:13. Traction relay
   11:14. Check of tension
   11:15. Detection of short circuit
   11:16. Check of reliability of grounding
   11:17. Check of integrity of a chain
   11:18. Finding of not closed chain
   11:19. Search of malfunctions
   11:20. Safety locks
   11:21. Fusible crossing points
   11:22. Breakers
   11:23. Relay
   11:24. Breaker of indexes of turn / alarm system
   11:25. Switch of indexes of turn
   11:26. Lock of ignition and drum of the lock
   11:27. Switch of external lighting
   11:28. Screen wiper switch
   11:29. Lamps of headlights
   11:30. Adjustment of headlights
   11:31. Headlight case
   11:32. Replacement of lamps
   11:33. Receiver and loudspeakers
   11:34. Antenna
   + 11:35. Screen wiper electric motor
   11:36. Switch of heating of back glass
   11:37. Heater of back glass
   11:38. Guard of devices
   11:39. Sound signal
   11:40. Electric drive of mirrors
   11:41. Cruise control
   + 11:42. Window regulator electric drive
   11:43. Electric drive of door locks
   11:44. Safety cushions
+ 12. Electrical circuitries



11:10. Generator

GENERAL INFORMATION

Fastening of the generator on 4-cylinder engines

1. Lock bolt
2. Axial bolt
3. Belt
4. Generator

Fastening of the generator on the V6 engine

1. Adjusting bolt
2. Generator
3. Lock-nut
4. Belt
5. Axial bolt

Removal and installation

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Disconnect sockets from the generator.
3. Weaken adjusting (In) and lock (And) bolts of the generator.
4. Turn out adjusting and lock bolts.
5. Turn out an axial bolt on the engine of 2,7 l.
6. Remove the generator and an arm from the engine.
7. If you decided to replace the generator, then keep in mind that the new generator has to correspond in accuracy to replaced. On many new generators there are no pulleys therefore it is necessary to rearrange a pulley from the replaced unit.
8. The generator is installed upside-down.

2403db43 2403db43