Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car



Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
- 11. Electric equipment
   11.1. Specifications
   11.2. Battery
   + 11.3. System of ignition
   11.4. Coil (i) of ignition
   11.5. Ignition distributor
   11.6. Check and installation of the moment of ignition
   11.7. Block of electronic ignition
   11.8. Induction sensor
   + 11.9. System of a charge of the battery
   + 11:10. Generator
   11:11. System of launch of the engine
   + 11:12. Starter electric motor
   11:13. Traction relay
   11:14. Check of tension
   11:15. Detection of short circuit
   11:16. Check of reliability of grounding
   11:17. Check of integrity of a chain
   11:18. Finding of not closed chain
   11:19. Search of malfunctions
   11:20. Safety locks
   11:21. Fusible crossing points
   11:22. Breakers
   11:23. Relay
   11:24. Breaker of indexes of turn / alarm system
   11:25. Switch of indexes of turn
   11:26. Lock of ignition and drum of the lock
   11:27. Switch of external lighting
   11:28. Screen wiper switch
   11:29. Lamps of headlights
   11:30. Adjustment of headlights
   11:31. Headlight case
   11:32. Replacement of lamps
   11:33. Receiver and loudspeakers
   11:34. Antenna
   + 11:35. Screen wiper electric motor
   11:36. Switch of heating of back glass
   11:37. Heater of back glass
   11:38. Guard of devices
   11:39. Sound signal
   11:40. Electric drive of mirrors
   11:41. Cruise control
   + 11:42. Window regulator electric drive
   11:43. Electric drive of door locks
   11:44. Safety cushions
+ 12. Electrical circuitries


2403db43

11:24. Breaker of indexes of turn / alarm system

GENERAL INFORMATION

Breaker of indexes of turn and alarm system

 

Check

PERFORMANCE ORDER
1. The breaker is mounted in the block of the relay and safety locks in salon
2. Normal operation of the breaker is followed by clicks. If one of indexes of turn does not work, and clicks are not listened, then it is necessary to check lamps.
3. If both indexes do not work, then burn-out of a safety lock (is in the block of safety locks of salon), malfunction of the breaker, switch or weakening of contacts is the reason. If the safety lock fused, then check existence of short circuit of conducting, and only after this check establish a new safety lock.

Replacement

PERFORMANCE ORDER
Breaker
1. For replacement of the breaker get it from a block in the block of safety locks of salon.
2. Track that the new breaker in accuracy corresponded to replaced.
3. Installation is carried out upside-down.
Switch of the alarm system
4. Hook and get the switch from a forward partition and disconnect the socket.
5. Check existence of a chain between conclusions 2 and 3 (it is a lighting chain). Transfer the switch to situation Off it (is switched off) and check existence of a chain between conclusions 7 and 10. Transfer the switch to situation On it (is included) and check existence of a chain between conclusions 5, 6 and 9 and conclusions 7 and 8.
6. If results of check negative, then the switch replace.