Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car


Toyota 4ranner
+ 1. Maintenance instruction
- 2. Maintenance
   2.1. Specifications
   2.2. Arrangement of knots and units
   + 2.3. Frequency of maintenance and types of scheduled works
   2.4. Intensive service
   + 2.5. Check of level of liquids
   2.6. Check of tires
   2.7. Check of level of liquid in automatic transmission
   2.8. Liquid level in system of a hydraulic actuator of steering
   2.9. Replacement of oil in the engine and an oil filter
   2.10. Care of the battery
   2.11. Check of the cooling system
   2.12. Check of a condition of the hoses located in a motor compartment
   2.13. Screen wiper brushes
   2.14. Shift of wheels
   2.15. Check of a suspension bracket of steering
   2.16. Lubricant of a running gear, suspension brackets, steering and details of a body
   2.17. Check of the exhaust system
   2.18. Check of level of oil in the manual transmission
   2.19. Check of level of oil in the transfer case
   2.20. Check of level of oil in a reducer
   2.21. Check of seat belts
   2.22. Check of covers of half shafts
   2.23. Zolotnik of ventilation of a case
   2.24. The filtering element of the air filter
   2.25. Belts of the drive of hinged units
   2.26. Check of fuel system
   2.27. Check of wear of brakes
   2.28. Check and adjustment of pedals of coupling (brake)
   2.29. Replacement of candles
   2.30. Check and adjustment of gaps in valves
   2.31. Replacement of the fuel filter
   2.32. High-voltage wires, runner and cover of the distributor
   2.33. Care of the cooling system
   2.34. Naves and bearings of forward wheels
   2.35. Replacement of liquid in automatic transmission and the filter
   + 2.36. Oil replacement
   2.37. Check of a tank with an absorber
   2.38. Valve check of system of recirculation
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries


2403db43

2.29. Replacement of candles
GENERAL INFORMATION

At acquisition of candles be guided by data on the information plate under a cowl.

PERFORMANCE ORDER
1. Believe a gap in new candles. If necessary turn in a side electrode for adjustment of a gap.
2. Disconnect wires, holding tips.
Prevention

On engines of 3,4 l V6 on which there is no distributor for access to candles remove the corresponding coils of ignition.
3. Clear platforms near vecha and turn out candles.
4. Check the turned-out candles and define a condition of the engine.
5. Grease carvings of new candles with structure from a holding strap, dress a piece of a hose on a candle and carefully wrap a candle. Tighten a candle with the set moment.
6. Dress wires, slightly rotating tips and pressuring them.