Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car

Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   - 3.1. 4-cylinder engines
      3.1.1. Specifications
      3.1.2. The types of repair which are carried out without removal of the engine from the car
      3.1.3. Installation of the piston of the 1st cylinder in compression step VMT
      3.1.4. Cover of a head of cylinders
      3.1.5. The soaking-up collector
      3.1.6. Final collector
      3.1.7. Cam-shafts and pushers
      3.1.8. Head of cylinders
      3.1.9. Cover of the chain drive of cam-shafts
      3.1.10. Forward epiploon of the crankshaft
      3.1.11. Oil pallet
      3.1.12. Oil pump
      3.1.13. Flywheel (drive plate of the hydrotransformer)
      3.1.14. Back epiploon of the crankshaft
      3.1.15. Engine mount details
   + 3.2. V6 3,0 engines of l (1993-1994) and 3,4 l (since 1995)
   + 3.3. Dismantle and capital repairs of the engine
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries

3.1.15. Engine mount details

GENERAL INFORMATION

Engine mount details as a rule do not demand leaving, however at detection of damage of support of the engine or their aging, they should be replaced immediately.

Check

PERFORMANCE ORDER

1. Lift the car and establish on supports, then place a support under the oil pallet of the engine. Lay a big board between the pallet and a support and carefully raise the engine to unload support. It is forbidden to substitute a board under a drain stopper of the pallet.
	2. Check existence on support (are specified by shooters) cracks, hardening or peeling from a metal basis.
3. Check whether plates of support concerning the engine move or a frame (for this purpose shake support mount, or the big screw-driver). If movement is felt, then lower the engine and delay fastenings of support.
4. For delay of aging grease rubber details of support with the preserving means.

Replacement

PERFORMANCE ORDER

1. Disconnect the battery from weight, lift the car and establish on supports.

2. Turn off nuts and bolts, raise the engine and remove a support.

3. Installation is carried out upside-down. Grease carvings of nuts and bolts with the fixing structure and reliably tighten.