Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
- 3.1. 4-cylinder engines
3.1.1. Specifications
3.1.2. The types of repair which are carried out without removal of the engine from the car
3.1.3. Installation of the piston of the 1st cylinder in compression step VMT
3.1.4. Cover of a head of cylinders
3.1.5. The soaking-up collector
3.1.6. Final collector
3.1.7. Cam-shafts and pushers
3.1.8. Head of cylinders
3.1.9. Cover of the chain drive of cam-shafts
3.1.10. Forward epiploon of the crankshaft
3.1.11. Oil pallet
3.1.12. Oil pump
3.1.13. Flywheel (drive plate of the hydrotransformer)
3.1.14. Back epiploon of the crankshaft
3.1.15. Engine mount details
+ 3.2. V6 3,0 engines of l (1993-1994) and 3,4 l (since 1995)
+ 3.3. Dismantle and capital repairs of the engine
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries
|
Details of the oil pump
1. Pump (chain cover)
2. Reducing valve
3. Springs
4. Plate
5. Lock ring |
6. Crankshaft epiploon
7. Pump cover
8. Leading rotor
9. The conducted rotor
10. Laying |
Removal
| PERFORMANCE ORDER |
| 1. Shoot belts and a video of a natyazhitel. |
| 2. Remove the pallet. |
| 3. Remove a crankshaft pulley. For access to the reducing valve uncover a chain. |
|
4. Unscrew 9 screws (ukazna shooters) and remove the case of the oil pump. |
| 5. Remove the consolidation remains from the demountable planes of the pump and block of cylinders, wash out the planes solvent. |
| 6. Get the conducting and conducted rotors. |
| 7. Carefully disassemble the reducing valve. |
|
Check
| PERFORMANCE ORDER |
| 1. Wash out all details in solvent, check existence of wear and damages. |
| 2. Check a condition of the sliding surface of the piston of the reducing valve and a spring. At detection of damages replace the piston complete with a spring. |
|
|
3. Check the probe a gap between the conducted rotor and the case. |
|
4. Check the probe a face gap of a rotor between a rotor and a cover. |
|
5. Check the probe a gap in gearing of the leader and conducted rotors. |
| 6. Compare results of measurements to standard. If gaps exceed norm, then replace rotors in a set. If necessary replace a pump housing (a chain cover). |
|
Installation
| PERFORMANCE ORDER |
| 1. Oil rotors for the engine and install in the case. |
|
|
2. Put technical vaseline in a pump cavity, lay laying, put a cover and tighten screws. |
| 3. Oil the piston of the reducing valve fresh for the engine and establish valve details. |
| 4. Establish new laying of a cover of a chain on the directing pins. |
| 5. Establish a chain cover, having entered the roller of the leading rotor of the oil pump into gearing with the leading gear wheel of the crankshaft. |
| 6. Establish other details upside-down. |
| 7. Fill in oil, start the engine, be convinced of lack of leaks. |
|
|
|
