| 1. Take off belts and a pulley of the crankshaft. |
|
|
2. Determine epiploon press fitting depth, then carefully get an epiploon from the case of the oil pump, having hooked the screw-driver or the special tool. |
| 3. Clear an opening under an epiploon in the case of the oil pump and slightly grease an external surface and working edges of a new epiploon with oil for the engine. |
|
4. Carefully without distortions press a new epiploon into place by means of a mandrel with a diameter a little smaller, than diameter of an epiploon. After installation be convinced that the provision of a spring of an epiploon is not violated. |
| 5. Establish other details upside-down. |
