Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car



Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
- 9. Suspension bracket and steering
   9.1. Specifications
   9.2. Springs and shock-absorbers (racks) of a forward suspension bracket
   9.3. Stabilizer of a forward suspension bracket
   9.4. Rotary fist
   9.5. Forward nave and bearing
   9.6. Spherical support
   9.7. Top lever
   9.8. Lower lever
   9.9. Back shock-absorbers
   9.10. Back stabilizer of cross stability
   9.11. Cross bar of the back bridge
   9.12. Back springs
   9.13. Longitudinal bars of the back bridge
   9.14. Steering wheel
   9.15. Tip of steering drafts
   9.16. Cover of the steering mechanism
   9.17. Steering mechanism
   9.18. Pump of the hydraulic booster
   9.19. Power steering
   9.20. Angles of installation of forward wheels
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries


2403db43

9.13. Longitudinal bars of the back bridge

Removal and installation

PERFORMANCE ORDER
1. Lift a back part of the car.
2. Establish supports under a bridge beam.
3. Disconnect conducting of sensors of speed from bars.
4. For removal of the top bar turn off nuts (are specified by shooters), remove washers and bolts of fastening to a frame and to the bridge.
5. For removal of the lower bar turn off nuts, remove washers and bolts of fastening to arms on a frame and the bridge.
6. Check a condition of plugs of bars.
7. At detection of damages of the plug replace (replacement is carried out in car service).
8. Installation of bars is carried out upside-down.
9. Finally tighten nuts of fastening of bars after lowering of the car.