Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car


Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
- 8. Brake system
   8.1. Specifications
   8.2. ABS system
   8.3. Blocks of disk brakes
   8.4. Brake support
   8.5. Brake disk
   8.6. Blocks of drum brakes
   8.7. Wheel cylinder of back brakes
   8.8. Main cylinder of brakes
   8.9. Hoses and tubes of a hydraulic actuator
   8.10. Pressure regulator
   8.11. Emergency brake
   8.12. Cables of the emergency brake
   8.13. Vacuum amplifier of brakes
   8.14. Pumping of brakes
   8.15. Adjustment of a pedal of a brake
   8.16. Braking signal switch
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries


2403db43

8.8. Main cylinder of brakes

 Removal and installation
PERFORMANCE ORDER
1. Substitute the pallet under the cylinder or spread rags.
2. Disconnect the socket from a tank.
3. Release the union of tubes on the main cylinder (it is recommended to release an alligator wrench). To the amplifier of brakes the cylinder fastens two nuts (are specified by shooters). Disconnect and muffle tubes.
4. Turn off 2 nuts of fastening of the cylinder to the vacuum amplifier and remove the cylinder.
5. Merge the liquid remains from a tank.
6. At installation fill the cylinder with liquid, – this measure considerably reduces time of pumping of brakes. Clamp the cylinder in a vice for a flange, fill in liquid in a tank and press the piston the big cross screw-driver. At an otpuskaniye of the piston clamp fingers of an opening of unions. Having pressed the piston several times, close openings caps.
7. Install the cylinder upside-down. Remove air from a hydraulic actuator.