Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car

Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
- 8. Brake system
   8.1. Specifications
   8.2. ABS system
   8.3. Blocks of disk brakes
   8.4. Brake support
   8.5. Brake disk
   8.6. Blocks of drum brakes
   8.7. Wheel cylinder of back brakes
   8.8. Main cylinder of brakes
   8.9. Hoses and tubes of a hydraulic actuator
   8.10. Pressure regulator
   8.11. Emergency brake
   8.12. Cables of the emergency brake
   8.13. Vacuum amplifier of brakes
   8.14. Pumping of brakes
   8.15. Adjustment of a pedal of a brake
   8.16. Braking signal switch
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries

8.4. Brake support

GENERAL INFORMATION

Prevention

At serious damages the support is recommended to be replaced.

Removal

PERFORMANCE ORDER

1. Release nuts of wheels, lift the car and establish on supports. Remove wheels.
2. Remove about 2/3 liquids from a tank (to exclude transfusion at cultivation of blocks). Clear a support and adjacent details.
	3. If the support changes, then turn off a hydraulic actuator union nut (bolts of the union are specified by shooters).
4. Turn off bolts and remove a support. If in a disk the fillet because of development was formed, then previously remove blocks.
5. Replace a support at detection of traces of a leak.
6. Assembly is carried out upside-down. Tighten bolts of a support with the set moment. Remove air from a hydraulic actuator (if understood).