Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car


Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
- 8. Brake system
   8.1. Specifications
   8.2. ABS system
   8.3. Blocks of disk brakes
   8.4. Brake support
   8.5. Brake disk
   8.6. Blocks of drum brakes
   8.7. Wheel cylinder of back brakes
   8.8. Main cylinder of brakes
   8.9. Hoses and tubes of a hydraulic actuator
   8.10. Pressure regulator
   8.11. Emergency brake
   8.12. Cables of the emergency brake
   8.13. Vacuum amplifier of brakes
   8.14. Pumping of brakes
   8.15. Adjustment of a pedal of a brake
   8.16. Braking signal switch
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries


2403db43

8.16. Braking signal switch
GENERAL INFORMATION

Braking signal switch

 The switch and the position of the switch are specified by shooters.

Check and replacement
PERFORMANCE ORDER
1. The switch is over a brake pedal.
2. If the switch does not close contacts, then check a safety lock and lamps of a signal of braking.
3. If these details are serviceable, then check presence of tension on the switch.
4. If tension is absent, then check wires. Otherwise be convinced that when pressing a pedal on the second contact tension appears. If there is no tension, then replace the switch. If tension appears, but lamps do not burn, then check a chain from the switch to lamps.
5. For replacement remove the lower facing of a steering column, disconnect from the wire switch, turn off a lock-nut and remove the switch.
6. Install the switch upside-down. Adjust the switch.