| 1. Remove a forward lattice. |
|
2. Outline a latch contour on a rack of a radiator and turn off fastening bolts (are specified by shooters). |
|
3. Take away a latch of a cowl and unhook a cable (the forward lattice is removed). |
| 4. Installation is carried out upside-down. |
| 5. At not tightened bolts adjust the provision of a latch and tighten bolts. |
| 6. For replacement of a cable disconnect brackets and latches on all route of its proleganiye. |
|
7. Remove the lower facing panel, get the cable lever from the forward panel and unscrew screws of fastening (arrow). |
|
8. Hook and get a cable from an arm and unhook from the lever. |
| 9. Fix on the end of a cable from salon a thin wire and extend a cable in a motor compartment. |
| 10. Installation is carried out upside-down. |
