Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car



Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
- 10. Body
   10.1. Maintenance and repair of a body
   10.2. Vinyl finishing
   10.3. Upholstery and rugs
   + 10.4. Repair of insignificant damages of a body
   10.5. Repair of considerable damages of a body
   10.6. Loops and locks
   10.7. Windshield and motionless glasses
   10.8. Cowl
   10.9. Latch of the lock of a cowl and cable
   10:10. Forward lattice
   10:11. Bumpers
   10:12. Facing panel of a door
   10:13. External mirror
   10:14. Door
   10:15. Forward wing
   10:16. Door of a cargo compartment
   10:17. Glass of a door of a cargo compartment and window regulator
   + 10:18. Glasses of doors
   10:19. Window regulator
   10:20. Lock clamp, switch of the lock and door handles
   10:21. Casing of a steering column
   10:22. Central floor section
   10:23. Panels of forward facing of salon
   10:24. Panel of forward facing of salon
   10:25. Air inlet lattice
   10:26. Seats
+ 11. Electric equipment
+ 12. Electrical circuitries


2403db43

10:15. Forward wing

Removal and installation

PERFORMANCE ORDER
1. Lift a front of the car and remove a wheel.
2. Remove indexes of turn.
3. Disconnect all devices of lighting which can interfere with removal of a wing.
4. Remove a forward lattice if feedwells of devices of lighting are built in it, or remove the lower facing of headlights.
5. Remove protective panels of wheel niches for what it is necessary to unscrew screws and to disconnect latches and brackets.
6. Turn off bolts of fastening of the top edge of a wing.
7. Open a door and turn off a bolt of fastening of the top back corner of a wing (it is specified by an arrow).
8. Turn off a bolt of the lower back edge of a wing which is directly behind a wheel niche (it is specified by an arrow).
9. Carefully remove a wing (it is recommended to work together).
10. If the wing changes, then remove a decorative overlay of an edge of a wheel niche.
11. For this purpose turn off 5 bolts, get 6 latches and drill 2 rivets. Drill rivets a drill, having wound it in 10 mm from top.
12. Installation is carried out upside-down.