1. Lift the car. |
2. Remove the ABS system sensor (if it is provided). |
3. Remove a back brake (see subsection 8.6). |
4. Disconnect a cable of the emergency brake and a tube from the wheel cylinder. |
|
5. Turn off brake board nuts (are specified by shooters). |
|
6. Carefully get a half shaft assembled. |
|
7. Get laying from a bridge flange. |
|
8. Get an epiploon, having hooked the screw-driver. |
9. Replacement of the bearing of a half shaft is carried out in car service. |
10. Accurately press a new epiploon by means of a mandrel, having greased edges. |
11. Establish new laying. |
12. Carefully establish a half shaft. |
13. Further assembly is carried out upside-down. |