Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car

Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
- 7. Transmission elements
   7.1. Specifications
   + 7.2. Coupling
   - 7.3. Cardan shaft and cardan hinges
      7.3.1. Check of driveshafts
      7.3.2. Removal and installation of the driveshaft
      7.3.3. Replacement of cardan hinges
   7.4. Back and forward axes
   7.5. Bearing, epiploon and half shaft of the back bridge
   7.6. Epiploon of a reducer of the back bridge and forward axis
   7.7. Zadny Bridge
   7.8. Forward half shafts
   7.9. Replacement of covers and dismantling of the CV JOINT
   + 7.10. Electromagnetic drive of a forward leading axis (ADD system)
   7.11. Forward reducer
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries

7.3.2. Removal and installation of the driveshaft

PERFORMANCE ORDER

1. Lift also a back part of the car.
Back shaft
	2. Designate the mutual provision of flanges of the driveshaft and the leading gear wheel of a reducer.
	3. Holding bolts, turn off four nuts of fastening of a flange of a back shaft.
	4. Disconnect the driveshaft from a back flange. Get a shaft from transmission or the transfer case, or turn off bolts of fastening of the hinge to a flange of the transfer case.
5. On rear wheel drive cars muffle an opening in the transmission.
6. Installation is carried out upside-down. Combine the tags put when dismantling and tighten nuts with the set moment.
Forward shaft
7. Remove the protection cover of a forward shaft.
8. Designate the mutual provision of flanges of a reducer, the transfer case and cardan hinges.
9. Holding bolts, turn off nuts of fastening of a shaft and remove a shaft.
10. Installation is carried out upside-down. Combine the tags put when dismantling and tighten nuts with the set moment. At first fix a shaft on a forward reducer, having tightened nuts by hand, and then – on the transfer case. Tighten bolts and nuts with the set moment.