Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car


Toyota 4ranner
- 1. Maintenance instruction
   1.2. Dashboard
   1.3. The combined devices
   1.4. Designation of symbols of light indexes
   1.5. Keys
   1.6. System of an immobilizer (recognition of a code of launch of the engine)
   + 1.7. Doors
   1.8. Cover of the fuel tank
   1.9. Adjustment of a front seat
   1.10. Adjustment of an inclination of a steering wheel
   1.11. Adjustment of provision of a rear-view mirror
   1.12. Plafond of internal lighting
   1.13. Plafond of individual lighting
   1.14. Cleaner and washer of a windshield
   1.15. Cleaner and washer of back glass
   + 1.16. Headlights and indexes of turn
   1.17. Heater of back glass
   1.18. Index of a reserve of fuel
   1.19. The remote thermometer of the cooling means
   1.20. Oil pressure measuring instrument
   1.21. Voltmeter
   1.22. Tachometer
   1.23. Counter of the general run and counter of a daily run
   + 1.24. Indexes and the warning signals
   1.25. Lock of ignition and lock of a steering column
   1.26. Automatic box
   1.27. The AM-UKV radio receiver with electronic control
   1.28. The AM-VHF-radio tape recorder with electronic control
   1.29. Adjustment of the direction of a stream of air
   1.30. Governing bodies of a heater
   1.31. Hours
   1.32. Lighter and ashtray
   1.33. Glove box
   1.34. A container for trifles
   + 1.35. Actions at refusal of launch of the engine
   1.36. Identification numbers of the car
   1.37. Identification number
   1.38. Manufacturer's certificate of origin
   1.39. VECI label
   1.40. Numbers on transmission units
   1.41. Car raising jack
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries


2403db43

1.27. The AM-UKV radio receiver with electronic control

Use of the radio receiver

PERFORMANCE ORDER
1. Turn on the receiver, having turned the PWR.VOL handle clockwise.
2. Adjust loudness further turning the PWR.VOL handle.
3. Be adjusted on the necessary station (see below subitem 1-10 and subitem 1-6).
4. For reception of VHF (FM) - radio station switch to the mode of reception of VHF (FM), choose the mode of a stereo or monophonic reception.
5. If transfer on a VHF stereo is accepted, then the receiver will automatically switch to reception of a stereo, at the same time on the display ST symbol will appear.
6. If a signal weak, then switch to the monophonic mode, having pressed the corresponding button. On the display MONO symbol will appear.
7. Adjust a timbre and balance (see below).
8. To switch off the receiver, turn the PWR.VOL handle against an hour hand.

Control for the station

PERFORMANCE ORDER
1. For the choice mono or stereoreception press the L.M/U button. On the display symbols of L.MW or UKW will appear.
2. Be adjusted on the necessary station by means of one of the ways offered below. On the display value of frequency of control will appear.
Control in the program mode
3. Press the button of the choice of the station which was in advance brought in memory. The receiver will automatically be adjusted on this station, and on the display number of the button will be displayed (see below).
4. Mode of continuous search. In this mode there is a search of the station. After reception of the station control automatically stops.
5. Press at the same time on both parties the TUNE buttons and wait for a continuous sound signal.
6. The receiver will begin to carry out automatically search of the nearest station with higher or lower frequency of broadcasting.
7. After consistent reception control stops.
8. By the subsequent pressing of the button search will continue before consistent reception of the following station.
9. If because of too weak signal it is not possible to be adjusted after single scanning of all range of frequencies, then search will continue, but at hypersensibility, and on the display the symbol DX will appear.
Manual control
10. Press at the same time on both parties the TUNE buttons for a while not exceeding 0,5 sec. By each pressing of the button there is a jump to the frequency at which broadcasting is possible.

Control programming

PERFORMANCE ORDER
1. Be adjusted on the necessary station (see above).
2. Press the button of the choice of the station and wait for a sound signal.
3. At the same time the station will automatically join when pressing this button which number will appear on the display.
4. On each button it is possible to remember one AM-station and one VHF station.
5. To bring control for the new station in memory repeat the procedure described above.
6. Control for the programmed station is erased at power off (a battery detachment, burn-out of a safety lock, etc.).

Reception of the ARI station (road information)

PERFORMANCE ORDER
1. Press the L.M/U button. On the display UKW symbol will appear.
2. Press the VF button. The receiver will switch to ARI reception mode, on the display VF symbol will appear.
3. Be adjusted on the necessary station broadcasting ARI information (see fig. above). After control for the ARI station on the display SK symbol will appear.
4. For ARI broadcasting cancellation repeatedly press the VF button.

Control of a timbre

It is provided with turn of the TONE handle.

Control of balance

PERFORMANCE ORDER
Pull on yourself the PWR.VOL handle and turn.