Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car

Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
- 6. Transmissions
   + 6.1. Mechanical transmission
   - 6.2. Automatic transmission
      6.2.1. Specifications
      6.2.2. Diagnostics of transmission
      6.2.3. Gate drive cable
      6.2.4. Draft of transmission
      6.2.5. The blocking switch
      6.2.6. System of fixing of transfers
      6.2.7. Lever of change of transfers
      6.2.8. Removal and installation of transmission
   + 6.3. Transfer case
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries

ремонт газовых котлов в Нижнем Новгороде тут.

6.2.5. The blocking switch

GENERAL INFORMATION

The switch blocks start of the engine in all provisions of the selector except P and N. Otherwise check or replacement of the switch is required.

Check

PERFORMANCE ORDER

1. Lift the car.
2. Disconnect the socket from the switch.
	3. At the switched-off ignition check resistance between switch conclusions (see the tab. Resistance between switch conclusions). If necessary adjust the switch or replace.

Adjustment

PERFORMANCE ORDER

1. Transfer the selector to situation N.
	2. Release a bolt of the switch (2) and adjust situation, for this purpose release a bolt, insert a flute (3) in the area of a neutral (1) and, holding the switch, tighten a bolt.
	3. For replacement of the switch you raskontrit a washer and turn off a nut.
4. Turn off a bolt and remove the switch.
5. Assembly is carried out upside-down. Adjust the switch.

Resistance between switch conclusions

Position of the selector	Normally closed conclusions	Normally closed conclusions
P	4 – 7	5 – 6
R	4 – 8	–
N	4 – 10	5 – 9
D	4 – 9	–
2	2 – 4	–
L	2 – 3	–