Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car

Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
- 6. Transmissions
   + 6.1. Mechanical transmission
   - 6.2. Automatic transmission
      6.2.1. Specifications
      6.2.2. Diagnostics of transmission
      6.2.3. Gate drive cable
      6.2.4. Draft of transmission
      6.2.5. The blocking switch
      6.2.6. System of fixing of transfers
      6.2.7. Lever of change of transfers
      6.2.8. Removal and installation of transmission
   + 6.3. Transfer case
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries

6.2.3. Gate drive cable

GENERAL INFORMATION

Bolts of the case of valves of transmission of A43D

Bolts of the case of valves of transmission of A34O

Check and adjustment

PERFORMANCE ORDER

1. Make sure that the butterfly valve is completely closed at the released pedal.
2. Check a cable tension.
	3. Check distance between a cover and the limiter of a cable.
4. If necessary adjust rotation of lock-nuts.

Replacement

PERFORMANCE ORDER

1. Disconnect a cable from draft (see subsection 5.9).
2. Exempt a cable from collars in a motor compartment.
3. Turn off a cable collar bolt on a hydrotransformer case.
4. Remove the pallet.
	5. On transmissions of A340F/A340E otvernit 3 bolts and remove solenoidal valves.

6. Remove tubes, on transmission of A43 they can be got, having hooked the screw-driver then it is necessary to unscrew 5 screws of the filter of rough cleaning (the drawing at the left). For removal of tubes on A340E transmission to a poddenta their screw-driver (the drawing on the right).
	7. In transmission of A340F there is only 1 tube. For removal to a poddenta a tube the screw-driver.
	8. Remove the filter of rough cleaning of transmission (if it is provided).
9. Turn off 17 bolts and remove the case of valves (cm. rice. Bolts of the case of valves of transmission of A43D and rice. Bolts of the case of valves of transmission of A34O). At assembly of the case of valves of transmission of A43D it is necessary to wrap bolts which have different length, in compliance with the scheme. At assembly of the case of valves of transmission of A430 it is necessary to wrap bolts in compliance with the scheme. Before an otvorachivaniye of the last bolt hold the case with the assistant.
	10. Lower the case and disconnect a cable from a cam.

11. Get a cable from transmission. On transmission of A43 push out a cable of 10 mm – a face head (the drawing at the left). On transmission of A340 turn off a bolt and get a cable (the drawing on the right).
12. Pass a new cable. On transmission of A340 tighten a bolt.
13. Attach a cable to a cam.

14. Before installation of the case of valves combine a flute on the valve of the manual drive with a pin on the lever (in the drawing A43 transmission, in the drawing on the right – A340 transmission is shown at the left).
	15. Bend a cable so that the radius of curvature was about 200 mm. Push a cable to feeling of weakness in resistance and a rasklepayta the limiter at distance of 0,8-1,5 mm from a cable cover end face.
16. Further assembly is carried out upside-down. If necessary adjust a cable.