Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car

Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
- 6. Transmissions
   - 6.1. Mechanical transmission
      6.1.1. Specifications
      6.1.2. A back epiploon of the check point (on rear wheel drive cars)
      6.1.3. Check point case support
      6.1.4. Check point control lever
      6.1.5. Removal and installation of the manual transmission
   + 6.2. Automatic transmission
   + 6.3. Transfer case
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries

6.1.2. A back epiploon of the check point (on rear wheel drive cars)

Replacement

PERFORMANCE ORDER

1. Wear of a back epiploon in a shaft of a case and the plug (if it is provided), and also an epiploon and a sealing ring of a reducer of a speedometer is a common cause of a leak in a case of the check point. These details can be replaced without removal of the check point.
2. Lift the car. The leak of an epiploon is noticeable by oily deposits on a forward part of the driveshaft, and also at a check point shaft end face.
3. Remove the driveshaft (see subsection 7.3.2).
4. Carefully displace a mud-reflector easy blows of the hammer with soft brisk.
	5. Hook and carefully get an epiploon.
6. If the epiploon does not give in to removal, then it should be got by means of the special tool (is available on sale).
	7. Press a mandrel a new epiploon, watching that the epiploon came without distortion.
8. Napressuyte mud-reflector.
9. Grease vents of a fork and a shaft and install the driveshaft, without having damaged at the same time an edge of a new epiploon.