Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
- 4. Systems of heating, ventilation
4.1. Specifications
4.2. Antifreeze
4.3. Thermostat
4.4. Krylchatka of the fan and hydraulic clutch
4.5. Radiator and tank
4.6. Oil cooler
- 4.7. Pump
4.7.1. Check
4.7.2. Removal and installation
4.8. Liquid temperature sensor
4.9. Electric motor and chain of the fan of a heater
4.10. Heater radiator
4.11. Control panel of the conditioning block
+ 4.12. Air conditioning system
4.13. Compressor
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries
|
The pump of cooling liquid on 4-cylinder engines
|
1. Laying
2. Pump
3. Belt
4. Pulley
|
5. Coupling
6. Krylchatka
7. Casing 1
8. Casing 2 |
4-CYLINDER ENGINES
| PERFORMANCE ORDER |
| 1. Disconnect the battery from weight and merge cooling liquid (see subsection 2.33). |
| 2. Take off all belts of hinged units. |
| 3. Remove a casing of the fan and the fan. |
| 4. Remove a pulley from the pump and disconnect hoses (see rice. The pump of cooling liquid on 4-cylinder engines). |
|
5. Turn off bolts and remove the pump. |
| 6. Carefully clear the demountable plane of a cover of the laying remains. |
| 7. Installation is carried out upside-down. Tighten bolts with the set moment. |
|
V6 ENGINE
Pump of the engine of 3,0 l
|
1. Inlet branch pipe
2. Thermostat
|
3. Laying
4. Pump |
Pump of the engine of 3,4 l
|
1. Laying
2. Inlet branch pipe
3. Pump
|
4. Thermostat
5. Cooler N2 hose |
Bolts of the pump of the engine of 3,0 l
|
|
Inhaling moment:
bolts And – 15,6 N. of m,
bolts In – 16,8 N. of m. |
| PERFORMANCE ORDER |
| 1. Disconnect the battery from weight and merge cooling liquid. |
| 2. Take off a gear belt. |
| 3. Remove an arm of the generator and remove the thermostat from the pump. |
| 4. Disconnect a cooler N2 hose from the pump. |
| 5. Turn off bolts and remove the pump (see rice. Bolts of the pump of 3,0 l). Disconnect hoses. |
| 6. Carefully clear the demountable plane of a cover of the consolidation remains. |
| 7. Installation is carried out upside-down. Apply the sealant roller on the plane of the pump. Tighten bolts with the set moment. Keep in mind that bolts of the pump of the engine of 3,0 l have the different sizes (see rice. Bolts of the pump of 3,0 l). |
|
|
|
