Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car

Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. 4-cylinder engines
   + 3.2. V6 3,0 engines of l (1993-1994) and 3,4 l (since 1995)
   - 3.3. Dismantle and capital repairs of the engine
      3.3.1. Specifications
      + 3.3.2. Capital repairs
      3.3.3. Diagnostics of the engine by means of the vacuum gage
      3.3.4. Check of a compression in engine cylinders
      + 3.3.5. Dismantle of the power unit
      + 3.3.6. Head of cylinders
      3.3.7. Valves
      3.3.8. Conrod and piston group
      + 3.3.9. Crankshaft
      3.3.10. Block of cylinders
      3.3.11. Honningovaniye of cylinders
      + 3.3.12. Rods and pistons
      3.3.13. Radical and conrod bearings
      3.3.14. Balancer shafts
      3.3.15. Assembly order
      3.3.16. Piston rings
      3.3.17. Launch of the engine after repair and a running in
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries

3.3.17. Launch of the engine after repair and a running in

PERFORMANCE ORDER

1. After the end of assembly check the level of oil and cooling liquid twice.

2. By the turned-out candlelight and the disconnected systems of ignition and the fuel pump turn the crankshaft until registration of pressure of oil the sensor.

3. Screw candles, dress tips of high-voltage wires and connect system of ignition and the fuel pump.

4. Start the engine. The engine has to be started immediately, later the short period necessary for increase of pressure of fuel.

5. Warm up the engine, watching closely emergence of leaks of oil or cooling liquid.

6. Stop the engine and check levels of oil and cooling liquid.

7. Accelerate the car from the speed of 50 km/h to 90 km/h, release a pedal of a butterfly valve, having slowed down the car the engine to the speed of 50 km/h. Repeat the cycle of 10-12 times. At the same time occurs extra earnings of piston rings to walls of cylinders. Double-check levels of oil and liquid.

8. Make a trip on 800 km, without subjecting the engine to big loadings (move at a low speed), periodically checking oil level. In the period of a running in the raised oil consumption is possible.

9. After the run of 900-1100 km replace oil and an oil filter.

10. At a run of the subsequent several hundred kilometers conduct the car in the normal mode, avoiding too big and too small loadings.

11. Later 3300 km of a run replace again oil and an oil filter then the engine is considered passed a running in.