Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and operation of the car

Toyota 4ranner
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. 4-cylinder engines
   + 3.2. V6 3,0 engines of l (1993-1994) and 3,4 l (since 1995)
   - 3.3. Dismantle and capital repairs of the engine
      3.3.1. Specifications
      + 3.3.2. Capital repairs
      3.3.3. Diagnostics of the engine by means of the vacuum gage
      3.3.4. Check of a compression in engine cylinders
      + 3.3.5. Dismantle of the power unit
      + 3.3.6. Head of cylinders
      3.3.7. Valves
      3.3.8. Conrod and piston group
      + 3.3.9. Crankshaft
      3.3.10. Block of cylinders
      3.3.11. Honningovaniye of cylinders
      + 3.3.12. Rods and pistons
      3.3.13. Radical and conrod bearings
      3.3.14. Balancer shafts
      3.3.15. Assembly order
      3.3.16. Piston rings
      3.3.17. Launch of the engine after repair and a running in
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. Suspension bracket and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries

3.3.11. Honningovaniye of cylinders

GENERAL INFORMATION

For a honningovaniye it is recommended to use brush adaptation.

PERFORMANCE ORDER

1. Clamp adaptation in the electric drill.
	2. Well oil the surface of the cylinder, turn on the electric drill and periodically move up and down in the cylinder.
	3. At the same time on a surface of walls of the cylinder the structure of the thin lines which are crossed at an angle about 60 ° has to be formed. To get the brush only after a full stop of a drill.

QX4.ONLINE
S40.ONLINE
A-8.ONLINE
W124.ONLINE
RX300.ONLINE
W140.ONLINE
B3-B4.SPACE
B3B4.SPACE
A-8.SPACE